Prepare your natural lashes by cleansing them thoroughly to increase durability.
1. Using an eyelash curler, gently curl your natural lashes, then carefully apply a thin, even layer of bond underneath them – a little goes a long way. Make sure to brush the lashes in a single direction so they don’t stick together.
2. For thinner lashes, it is recommended to apply two coats of bond, while for thicker lashes, one coat is sufficient. Allow the bond to dry and become slightly tacky by waiting for approximately 20 to 30 seconds.
3. Apply lash clusters under the base of your natural lashes, making sure they are positioned slightly away from the waterline to prevent potential irritation - around 1-2mm.
4. Once you are satisfied with the application, squeeze the lashes together to blend both the lash band and the individual clusters - creating a natural look.
5. To remove any residue or excess glue, carefully apply a thin layer of sealer above and below your lashes, focusing on the areas where you feel it is needed.
Tip: We recommend waiting 24 hours before bathing after applying lash clusters. When bathing, avoid getting water directly on your lashes.
Removal
1. Apply our lash cluster remover and wait for approximately 30 seconds.
2. Remove our lash clusters
3. Reapply our lash cluster remover and wait 1-2 minutes.
4. If necessary, repeat the process to ensure complete removal of any remaining residue.
Recycling
Place your used Lash Clusters on a paper towel, coat with Lash Cluster Remover or oil-free makeup remover, and let sit for 10 seconds. Then fill a cotton swab with remover and gently wipe away any remaining glue from the lashes.
For recycling, the bouquets must be completely dry.
NOTE: Recycling requires good care and careful cleaning.